Processing Capabilities

H. Cross Company Processing Capabilities

H. Cross Company can perform a wide range of processing tasks on all types of materials including the following:

• Rolling
• Drawing
• Heat Treating
• Cut Pieces
• Slitting
• Annealing
• Electropolishing
• Re-Drawing
• Re-rolling
• Toll-rolling
• Slitting

Rolling

We can process materials down to .0003″ thickness and tolerances of .000025″ when necessary.

Surface finishes down to 2 micro-inch are possible with our special polished rolling equipment.

(See specific material for Typical Dimensions and Tolerances of products.)

Drawing

Wire drawing from .125″ down to .002″
(See specific material for Typical Dimensions and Tolerances of products.)

Re-Drawing

H. Cross Company can redraw existing wire diameters to smaller and tighter tolerance diameters on one of our draw benches.

Cut Pieces

We can provide ribbon, strips and wire custom cut to length from .050″ to 48″ long with minimal or no burrs with excellent flatness. (Contact Us for more specific information.)

Slitting

We can slit materials as narrow as .020″ depending on the thickness and widths up to 6″ wide depending on material.

(See specific material for Typical Dimensions and Tolerances of products.)

Electropolishing

We can electro-polish your materials to improve surface finish for critical applications.

Re-rolling

We can re-roll most products up to 3″ wide if you have obsolete inventory due to product/design changes. We are capable of rolling most materials down to .001″ or lower. Why waste material when we may be able to re-manufacture it to fit your newer requirements.

Toll-rolling

We can fabricate customer-supplied materials to suit R & D projects, specialized customer requirements or anything else you cannot perform in house.